SET FORMWORK REBAR + 2x TOGGLE NUTS

A formwork rebar is a tie-down construction element. The formwork rod is most commonly used to fasten the formwork tops together when formwork is being constructed.

There may be a layer of iron oxide on the tie rod (the result of the natural oxidation process of iron, but this does not affect the load-bearing capacity and strength of the element).

The toggle nut will be useful for you to connect formwork at an angle. Thanks to special handles, it is easier to tighten or loosen the nut.

The flat base replaces the thrust washer. The toggle mechanism allows you to adjust the angle of the nut with respect to the base up to 15 degrees.

TECHNICAL DATA:

• The extractor is weldable
• The diameter of the puller: 15/17 mm
• Nut suitable for 15/17 tie downs
• Fits for Tekko type formwork, Rasto type formwork

We provide:

Friendly and professional service

Loading and transportation (courier, shipping, own transport)

Transportation throughout Europe

Technical and operational documents

Declaration of conformity

We encourage you to contact us.