CEILING SUPPORT ITALIAN TYPE USED

The construction support is used to support H20 girders. The props are used during formwork set-up. The strength of the entire formwork system depends on the support. They are also suitable for supporting lintels or balconies.

The steel makes the supports durable and gives you solid support. The internal adjustment thread allows you to set the seatpost to the millimetre. 

The supports were tested for strength at the Regional Construction Laboratory of the Department of Engineering Structures, Faculty of Civil and Environmental Engineering, Gdansk University of Technology.

The supports are made of pre-galvanised weatherproof material 

TECHNICAL DATA:

• Load bearing capacity: 10 kN

• Galvanised steel

• Internal adjusting thread

• Safety holes every 12.5 cm

• Base thickness: 4 mm

• Holes in the bases allowing the supports to be bolted together

• Outer pipe fi: 56 mm/wall thickness: 1.6 mm

• Inner tube fi: 48 mm/wall thickness: 1.6 mm

• Compliance with EU standards

• Used (shows signs of corrosion)